Consort Display Group

KBW BannerFlex Banner Brackets Are Easy to Install and Maintain

The BannerFlex products are designed to fit most any contour and cross-section of utility poles. Once you have chosen the proper bracket for your project, the installation is not complicated.

Pole Mounting With Banding

Simply fasten the Main Bracket Castings to your pole with proper stainless steel bands, as detailed in our banding chart.

Also, see the KBW BannerFlex literature page for more installation information

Shop now on bannerflex.com


Tool-Applied Steel Banding
Tool-Applied Steel Banding

The Banding Tool

For best results when mounting on poles, use 3/4” wide Band-It and we guarantee long-term mounting. Try it! You may think it’s difficult but once you install your first banner bracket you’ll see it’s easy and virtually permanent. For detailed instructions by product, visit our literature & video page.

Shop now on bannerflex.com


Tie-Down Mount
Tie-Down Mount

Tie-Down Mount Bracket

The Tie-Down Mount is a quick installation requiring only the Mount and 5/8” Screw Gear Banding. The heavier, ¾ tool-applied banding may be used if that is preferred or more convenient.

Simply locate the height and position on the light pole that matches the height of the lower grommet on the banner and thread the banding through the two slots on the Mount, wrap around the pole and tighten the banding.

Next, install an 18 gauge or heavier wire, or zip tie, through the Tie-Down Mount hole and then through the banner grommet.

Note:  heavier wire will generally last longer in this instance than a plastic zip tie. It is best if there is not very much “play” or distance between the Mount and the banner.

Note: Brackets may also be bolted to poles and wall surfaces using the holes in the Main Castings. See our wall-mount page for more information.

Shop now on bannerflex.com